Design and FEM analysis of equipment and conductors made of fiber reinforced plastic (FRP)
There are many sectors (chemical and process industry, naval, aeronautical or food sector) and industrial applications in which it is necessary to design and validate equipment made with special materials (FRP- Fiberglass Reinforced Plastic), due to to the special corrosion resistance requirements for which they have to provide service. This is the case of pressure […]
Fitness for service procedures for cracks like flaws
During the life cycle of many pressure vessels arise the necessity to maintain them in service after detecting crack-like flaws or delamination. For that, there are some methodologies that allow establishing a quantitative judgment about if it is possible to safely operate this equipment and also determine its remaining life until it must be repaired […]
STRESS ANALYSIS OF PIPES WITH RATIO D / t> 100
On certain occasions, during the development of projects where large diameter pipes are involved, scenarios arise in which the diameter (D) / thickness (t) ratio is higher than 100. It is common to find this situation in systems with large diameter pipes that work at low pressure, in which the calculated thickness due to the […]
CFD analysis of heat recovery boilers– HRSG
Computational Fluid Dynamics (CFD analysis) simulation of HRSG Boilers turns out to be a powerful engineering methodology in order to determine an optimal design to achieve maximum efficiency and avoid future operation issues, (such as incorrect mixing ratio, asymmetric burner performance, among others.). This type of simulations allows to analyze the behaviour of the chemical […]
Fitness for Service – Alternatives for equipment validation
Boiler and pressure equipment manufacturers face everyday strict design and manufacturing requirements to supply heat exchangers, pressure vessels or process equipment. The recognized international design and manufacturing codes that are prescribed for this type of equipment (ASME VIII Div. 1 & 2, EN13445, AD2000, etc.) specify those tests, trials, inspections and quality controls to be […]
Brief introduction to TEMA HEAT EXCHANGERS design and selection
TEMA Standards are worldwide accepted as the authority on shell and tube heat exchangers design and manufacturing. These standards are the most commonly used in a wide range of industries throughout the world: refineries, oil and gas, power generation, etc.
Structural simulation of railway rolling stock using finite element method analysis
ADVANTAGES OF INCORPORATING THE SUSPENSION SYSTEM TO THE FINITE ELEMENT MODEL
CADE is attending to NAFEMS World Congress 2013 in Salzburg (Austria)
The NAFEMS World Congress 2013, being held in Salzburg, Austria in June 2013 will be the only independent, global conference that focuses entirely on simulation and its impact on industry and beyond. As the international association dedicated to engineering analysis and simulation, NAFEMS has gained respect as being the independent voice of the CAE community, […]